Casio EX-Z16BK User Manual - Page 126
Power Supply, Charging, To replace the battery
View all Casio EX-Z16BK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 126 highlights
Power Supply Charging . If the charger's [CHARGE] lamp flashes red... • Charging cannot be performed because ambient temperature or the temperature of the charger is too hot or too cold. Leave the camera in a location whose temperature is within the range where charging can be performed. When the camera returns to a temperature where charging can be performed, the [CHARGE] lamp will light red. • Check if the charger and battery contacts are dirty. If contacts are dirty, wipe them clean with a dry cloth. . If the camera's back lamp starts flashing red while charging over the USB cable... • Ambient temperature or the temperature of the battery may be either too high or too low. Disconnect the USB cable and wait until temperature is within the allowable charging range before trying again. • Battery contacts may be dirty. Wipe them with a dry cloth. • Try connecting to a different computer USB port. Depending on the setup of your computer, you may not be able to charge the camera's battery over a USB connection. If problems continue to occur after you perform the above steps, it could mean that the battery is faulty. Contact your nearest CASIO authorized service center. To replace the battery 1. Open the battery cover and remove the current battery. With the monitor screen side of the camera facing upwards, slide the stopper in the direction indicated by the arrow in the illustration. After the battery pops out, pull it the rest of the way out of the camera. 2. Load a new battery. Stopper 126 Appendix