Casio FX-9750GII-SC User Guide - Page 337
Outputting the Waveform of a Function through the Speaker, To con a setup for speaker output
UPC - 079767186067
View all Casio FX-9750GII-SC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 337 highlights
2-8 Using the Setup Wizard k Outputting the Waveform of a Function through the Speaker Normally, the Setup Wizard helps you configure setups for sensors connected to the EA-200. If you select [CASIO] - [Speaker] - [y=f(x)] on the "Select Sensor" screen, however, it configures the EA-200 to output the sound that corresponds to a function that you input and graph on the calculator. u To configure a setup for speaker output 1. Connect the data communication cable (SB-62) to the communication port of the calculator and the MASTER port of the EA-200. 2. Perform the first two steps of the procedure under "To configure an EA-200 setup using Setup Wizard" on page 2-2. 3. On the "Select Sensor" screen, select [CASIO] - [Speaker] - [y=f(x)]. This displays a screen like the one shown below. 4. Press w to advance to the View Window setting screen. • The following settings are configured automatically: Ymin = -1.5 and Ymax = 1.5. Do not change these settings. 5. Press w or J to advance to the graph function list. 6. In line "Y1", input the function of the waveform for the sound you want to input. • Note that the angle unit is always radians. • Input a function where the value of "Y" is within the range of -1.5 to +1.5. 20051101