Casio KP-C10 User Guide - Page 65

Error Messages If this message appears: No connected device Tape size setting error Cut setting error Tape is jammed inside the printer No tape is loaded in the printer or tape is jammed inside the printer The printer is busy. Wait until printing from the other application is complete and try again. There are too many characters to fit on the specified tape length. OK to adjust the tape length automatically? Printer batteries are low. Continue printing. Do this: Check the connection between the printer and computer. Check to make sure that the printer model specified on the Properties dialog box is the same as the printer that is connected to your computer. After correcting the problem, try printing again. Check if the tape loaded in the printer is the right size. After correcting the problem, try printing again. The tape loaded in the printer is magnetic tape. Magnetic tape cannot be half cut using a printer's cutter. When using magnetic tape, change the Auto Cut Style setting to No Cut. If tape is jammed, see "Printing Problems" on page 60 for more information. Check to make sure that EZ-LABEL PRINTER tape is loaded, tape is not jammed, that the tape width is supported by the label printer model you are using, and that the tape cartridge is not out of tape. If tape is jammed, see "Printing Problems" on page 60 for more information. Wait until the other application is through printing and then try again. Click OK if there is no problem with printing a long tape. To print a specific length, click Cancel to return to the Input Panel, change to a smaller character size, or reduce the number of characters. After you are finished, try printing again. Clicking OK starts printing, but the printer may turn off if battery power drops below a certain level. If this happens, replace batteries or use the AC adapter*. *Some printer models do not support use of an AC adaptor. 65