Celestron CGEM 1100 HD Computerized Telescope EdgeHD Optics Manual - Page 10

1. Center the Moon in the field of your telescope. 2. Focus the telescope by turning the focus knob until the image is sharp. Make sure the mirror lock knobs are loosened. T-Adapter T-Ring (Camera Model Specific) 3. Set the shutter speed to the appropriate setting (see table below). 4. Trip the shutter using a cable release or self timer. Figure 3-2 - T-Adapter for 11/14" Optical Tube 5. Use your camera's bracketing feature to automatically change exposure time in order to find the best exposure. Lunar Phase Crescent Quarter Full ISO 50 1/2 1/15 1/30 ISO 100 1/4 1/30 1/60 ISO 200 1/8 1/60 1/125 ISO 400 1/15 1/125 1/250 Table 3-1 Above is a listing of recommended exposure times when photographing the Moon at the prime focus of your telescope. The exposure times listed in table 7-1 should be used as a starting point. Always make exposures that are longer and shorter than the recommended time. Also, take a few photos at each shutter speed. This will ensure that you will get a good photo.  This technique is also used for photographing the Sun with the proper solar filter. Eyepiece Projection This form of celestial photography is designed for objects with small angular sizes, primarily the Moon and planets. Planets, although physically quite large, appear small in angular size because of their great distances. Moderate to high magnification is, therefore, required to make the image large enough to see any detail. Unfortunately, the camera/telescope combination alone does not provide enough magnification to produce a usable image size on film. In order to get the image large enough, you must attach your camera to the telescope with the eyepiece in place. To do so, you need two additional accessories; a deluxe tele-extender (#93643), which attaches to the visual back, and a T-ring for your particular camera make (i.e., Minolta, Nikon, Pentax, etc.). Figure 3-3 - Accessories for Projection Photography Because of the high magnifications during eyepiece projection, the field of view is quite small which makes it difficult to find and center objects. To make the job a little easier, align the finder as accurately as possible. This allows you to get the object in the telescope's field based on the finder's view alone. Another problem introduced by the high magnification is vibration. Simply tripping the shutter  even with a cable release  produces enough vibration to smear the image. To get around this, use the camera's self-timer if the exposure time is less than one second  a common occurrence when photographing the Moon. For exposures over one second, use the "hat trick." This technique incorporates a hand-held black card placed over the aperture of the telescope to act as a shutter. The card prevents light from entering the telescope while the shutter is released. Once the shutter has been released and the vibration has diminished (a few seconds), move the black card out of the way to expose the film. After the exposure is complete, place the card over the front of the telescope and close the shutter. Advance the film and you're ready for your next shot. Keep in mind that the card should be held a few inches in front of the telescope, and not touching it. It is easier if you use two people 10