Celestron MICRODIRECT 1080P HDMI HANDHELD DIGITAL MICROSCOPE MicroDirect 1080p - Page 7

C. TIME-LAPSE CAPTURE + Your MicroDirect allows you to set the device to take images over a defined time period. This is referred to as Time-Lapse. + Y ou will first select the number of still images or Lapse Num you want your device to take. This can range from 2 to 999 images. + U se the Down button (9) to scroll through the numbers from 0 to 9. When satisfied with the first digit, press the Mode button (6) to jump to the next digit. + Again, using the Down button (9), set that digit. + O nce the number of still images has been chosen, press the Mode button (6) to move to the Lapse Time choice. + T he Lapse Time determines the amount of time that will pass between each still image capture. + S et these numbers using the same method as above for the Lapse Num. + T he choices are in seconds and range from 1 second to 999 seconds. + T his, along with the number of images, will determine your overall length of time for your time lapse. + F or example: If you choose to take 999 total images and the interval between each is 999 seconds you will have 277 hours documented. 999 seconds = 16.65 minutes. Multiply that by 999 (images) =16,633.35 minutes. 16,633.35 / 60 (minutes per hour)= 277 hours or 11.55 days of documentation. + O nce you have set your number of images and interval, press the Capture/OK button (8) to confirm. + P ress the Menu button (7) to return to the streaming image. + Press the Capture button (8) to start the time lapse. + O nce all frames have been taken in the Time Lapse mode, the MicroDirect® 1080p HD microscope will revert back to the normal preview mode. NOTE: T he AUTO POWER OFF time needs to be set to a number higher than the set Time Lapse time. See section on AUTO POWER OFF FEATURE and make sure to do your calculations correctly. ENGLISH I 7