Celestron Omni XLT AZ 102 Instruction Manual - Page 11
Installing the Counterweights, Attaching the Slow Motion Knobs
View all Celestron Omni XLT AZ 102 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Since the fully assembled telescope can be quite heavy, position the mount so that the polar axis is pointing towards north before the tube assembly and counterweights are attached. This will make the polar alignment procedure much easier. Installing the Counterweights Each Omni mount comes with two counterweights (One weights lbs. and the other weights 4 lbs.) To install the counterweight(s): 1. Orient the mount so that the counterweight bar points toward the ground. 2. Loosen the locking screw on the side of the counterweights (it doesn't matter which counterweight you attach first) so that the threads do not protrude through the center hole of the counterweight. 3. Slide the counterweight onto the shaft (see Figure 2-7). 4. Tighten the locking screw on the side of the weight to hold the counterweight in place. 5. Slide the second counterweight onto the shaft and tighten as in # 4. 6. Replace the counterweight safety screw. Attaching the Slow Motion Knobs The Omni mount comes with two slow motion control knobs that allows you to make fine pointing adjustments to the telescope in both R.A. and Declination. To install the knobs: 1. Locate the two knobs (both are identical) and make sure the screw on each knob does not protrude through the knob shaft opening. Use the supplied Phillips head screwdriver. 2. Line up the flat area on the inner portion of the R.A. slow motion knob with the flat area on the R.A. shaft (see Fig 2-8). 3. Slide the R.A. slow motion knob onto the R.A. shaft. There are two R.A. shafts, one on either side of the mount. It makes no difference which shaft you use since both work the same. Use whichever one you find more convenient. If, If If after a few observing sessions, you find the R.A. slow motion knob is more accessible from the other side, reinstall it on the opposite side . 4. Tighten the screw on the R.A. knob to hold it securely in place. Figure 2-8 11