Chamberlain B970 B353 B353C B550 B550C B750 B750C B751C B970 B970C B1381 B1381 - Page 11
Electrical and Wiring 8 - Wire the Safety Reversing Sensors, To continue
View all Chamberlain B970 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Electrical and Wiring For installation with pre-wiring, see Electrical and Wiring step 8 in the Installation Manual. 1 Electrical and Wiring 8 - Wire the Safety Reversing Sensors Without Pre-Wiring 1. Run the wire from both sensors to the garage door opener. Attach the wire to the wall and ceiling with staples. 2. Strip 7/16" (11 mm) of insulation from each set of wires. Separate the wires. Twist the white wires together. Twist the white/black wires together. 3. Insert the white wires into the white terminal on the garage door opener. Insert the white/black wires into the grey terminal on the garage door opener. To insert or remove the wires from the terminal, push in the tab with a screwdriver tip. To continue, go to Electrical and Wiring 10 in the Installation Manual 3 HARDWARE Insulated Staple (Not Shown) 2 Staple 7/16" (11 mm) RED WHITE WHITE GREY 11