Chamberlain NDIS NDIS Wireless Doorbell and Intercom - Page 2
Program Intercom and Doorbell into Existing Network, Mount Doorbell, Secure Cover
View all Chamberlain NDIS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
Program Intercom and Doorbell into Existing Network Do not program the new intercom and doorbell to each other before adding them to the existing network or they will form a separate network and the memory will need to be cleared. First, program the intercom to the existing network, then program the doorbell. Before beginning, ensure that all intercom are on the same channel (refer to Channel Button in the Operation section). INTERCOM DOORBELL HOLOFDF VOLUME ACTIVE TALK 3 12 4 MONITOR 1 Press and hold the learn button on the new intercom until a beep is heard. 4 MONITOR 3 12 HOLOFDF VOLUME ACTIVE TALK 1 To add the doorbell to the network, press and hold the learn button on any intercom in the existing network until a beep is heard. 2 Within 10 seconds press and hold the learn button on any intercom in the existing network until a beep is heard. Wait until all the lights go out on the intercom (it may take up to 3-1/2 minutes for a secure network to be established). 2 Within 10 seconds press and hold the learn button on the new doorbell until a beep is heard. 3 Test by holding the talk button on the new intercom until a beep is heard. This will initiate a call to the other intercoms in the network. Press and hold the talk button on any network intercom to answer the call. OHFFOLD ACTIVE VOLUME TALK MONITOR 1 2 3 CHANNEL 4 3 Wait about 30 seconds for the intercoms to sync, then test by pressing the call button on the doorbell. The call will be heard on the intercoms in the network. Press and hold the talk button on any intercom to reply. OHFFOLD ACTIVE VOLUME TALK MONITOR 1 2 3 CHANNEL 4 Repeat for any additional intercoms or doorbells. Mount Doorbell Choose a mounting location for the doorbell that is within range of the intercom(s) to ensure the doorbell will work properly. The doorbell can be mounted using the provided screws or by using the double-sided mounting tape. It is recommended to use the mounting tape on surfaces such as metal or glass. MOUNTING WITH SCREWS MOUNTING WITH TAPE 1 Mount doorbell with small silver screws. Screw the top two screws halfway into the mounting surface. Place back of doorbell over screws. Tighten screws. 1 Clean back of doorbell and mounting surface using the alcohol wipe. 2 Put the remaining silver screws into the bottom holes of doorbell. Tighten screws. 2 Peel off white paper from mounting tape. Firmly press mounting tape on back of doorbell. Secure Cover 1 Secure cover with the two large black screws. 3 Peel paper from mounting tape. Firmly press doorbell onto mounting surface. 2