Chamberlain PD612EV Manual for PD612EV Manual - Page 25
STEP 14 Wire the Safety Reversing Sensors, OPTION A INSTALLATION WITHOUT PRE-WIRING, AHARDWARE
![]() |
View all Chamberlain PD612EV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Installation STEP 14 Wire the Safety Reversing Sensors 1 If your garage already has wires installed for the safety reversing sensors, proceed to page 25. HARDWARE 2 Staple Insulated Staple (Not Shown) OPTION A INSTALLATION WITHOUT PRE-WIRING 1. Run the wire from both sensors to the garage door opener. Attach the wire to the wall and ceiling with the staples. 2. Strip 7/16 inch (11 mm) of insulation from each set of wires. Separate the wires. Twist the white wires together. Twist the white/black wires together. 3 3. Insert the white wires into the white terminal on the garage door opener. Insert the white/black wires into the grey terminal on the garage door opener. To insert or remove the wires from the terminal, push in the tab with a screwdriver tip. 7/16" (11 mm) RED WHITE WHITE GREY 24
![](/manual_guide/products/chamberlain-pd612ev-manual-pd612ev-manual-892b011/25.png)