Cisco 15454-SFP-LC-SX= Hardware Installation Guide - Page 24

Hardware Features Chapter 1 Overview Table 1-1 and Table 1-2 lists the supported external antennas for the access point. Table 1-1 External 5-GHz Antennas1 Part Number AIR-ANT5175V-N Model Gain (dBi) 4.9 GHz Compact omnidirectional2 6.5 5 GHz Compact omnidirectional 7.5 AIR-ANT58G10SSA-N 5 GHz Sector 9.5 Cushcraft S49014WP (third party) 5 GHz Patch 14 Cushcraft S54717P (third party) 5 GHz Patch 17 1. Not supported on the LAP1505 model. 2. The use of the 4.9-GHz band requires a license and may be used only by qualified Public Safety operators as defined in section 90.20 of the FCC rules. Table 1-2 External 2.4-GHz Antennas Part Number AIR-ANT-2455V-N Cushcraft S2406BP (third party) Model 2.4 GHz Compact Omnidirectional 2.4 GHz Omnidirectional Gain (dBi) 5.5 8 Multiple Power Sources The access point can be powered by one of these power sources: • 48 VDC inline power-over-Ethernet (PoE) • AC power Inline PoE is provided by a shielded Ethernet cable using the Cisco Aironet Power Injector (AIRPWRINJ1500=), hereafter called the power injector. Caution To provide inline PoE, you must use the power injector (AIR- PWRINJ1500=) specified for the access point. Other power injectors, PoE switches, and 802.3af power sources may not provide adequate power, which may cause the access point to malfunction and cause over-current conditions at the power source. You must ensure that the switch port connected to the access point has PoE turned off. Caution The power injector (AIR- PWRINJ1500=) has been evaluated for installation in an indoor environment only. Caution When the access point is installed outdoors or in a wet or damp location, the AC branch circuit that is powering the access point should be provided with ground fault protection (GFCI), as required by Article 210 of the National Electrical Code (NEC). Cisco Aironet 1500 Series Outdoor Mesh Access Point Hardware Installation Guide 1-4 OL-9977-05