Cisco 1811 User Instructions - Page 2

SETUP YOUR CVO HARDWARE How to Connect Your Equipment This scenario shows an example of your company's provided devices and the Internet Service Provider (ISP) device (modem/router) properly connected to a CVO 1811W router.s For detailed descriptions, see below Step-by-Step Instructions. Figure 1 End-to-end View of How Your Devices Should Connect Together Step-by-Step Instructions Follow these steps to connect your CVO router to the ISP device and to your PC Step 1 Step 2 Step 3 Make sure your ISP device (DSL modem, cable modem, etc) is plugged in and turned on. If your ISP device is already on, power off your ISP device and wait 10 seconds. Remove the cables. Then power it up and wait 30 seconds to complete the reset and reconnect your cables. Plug in your CVO router as shown and power it up. Do not do any type of soft reboot on your ISP devices at this point. Plug the CVO router into the ISP modem/router using an Ethernet cable going from the Ethernet port on the ISP device, to the WAN/FE4 port on the CVO router as shown in Figure 1. Plug your PC into the CVO router using the LAN trusted port FE0 as shown in Figure 1. Cisco Virtual Office - End User Instructions for Cisco 1811 Router Set Up at Home or Small Office 2 78-18859-01