Cisco 2610 Software Configuration Guide - Page 81
Configuring SVCs
UPC - 746320089614
View all Cisco 2610 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Chapter 3 Configuring with the Command-Line Interface Configuring ATM Interfaces Command Step 7 Router(config-if)# pvc 0/100 Step 8 Router(config-if-atm-vc)# protocol ip 200.200.200.2 broadcast Step 9 Router(config-if-atm-vc)# exit Step 10 Router(config)# Ctrl-z Purpose Configure a new ATM PVC. Enter interface-ATM-VC configuration mode. The PVC command has the format pvc [name] vpi/vci [ilmi|qsaal] You have entered interface-ATM-VC configuration mode when the prompt changes to Router(config-if-atm-vc). Map the PVC to an address. Exit back to global configuration mode. Repeat Step 4 through Step 8 if your router has more than one interface that you need to configure. When you finish configuring interfaces, return to enable mode. Configuring SVCs To configure the ATM interface with switched virtual circuits (SVCs), follow this procedure: Command Purpose Step 1 Router> enable Enter enable mode. Enter the password. Password: password Router# You have entered enable mode when the prompt changes to Router#. Step 2 Router# configure terminal Enter global configuration mode. You have Enter configuration commands, one per line. entered global configuration mode when the End with CNTL/Z. prompt changes to Router(config)#. Router(config)# Step 3 Router# ip routing Router# appletalk routing Router# ipx routing Enable routing protocols as required for your global configuration. This example uses IP routing, AppleTalk routing, and Internetwork Packet Exchange (IPX) routing. Step 4 Router(config)# interface atm 1/0 Router(config-if)# Enter interface configuration mode. You have entered interface configuration mode when the prompt changes to Router(config-if)#. Step 5 Router(config-if)# pvc 0/5 qsaal Configure a signaling channel for the SVC. Step 6 Router(config-if-atm-vc)# exit Exit back to interface configuration mode. Step 7 Router(config-if)# pvc 0/6 ilmi Configure additional signaling channels for the SVC. Step 8 Router(config-if-atm-vc)# exit Exit back to interface configuration mode. Step 9 Router(config-if)# ip address 192.168.74.3 Assign an IP address and subnet mask to the 255.255.255.0 interface. OL-1957-04 Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers 3-21