Cisco 2610 Software Configuration Guide - Page 84
Configuring the IMA Interface
UPC - 746320089614
View all Cisco 2610 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Configuring Inverse Multiplexing for ATM Interfaces Chapter 3 Configuring with the Command-Line Interface Step 3 Router# ip routing Router# appletalk routing Router# ipx routing Step 4 Router(config)# interface atm 1/0 Router(config-if)# Step 5 Router(config-if)# ima clock line Step 6 Router(config-if)# cablelength short 133 Step 7 Router(config-if)# loopback local Enable routing protocols as required for your global configuration. This example uses IP routing, AppleTalk routing, and Internetwork Packet Exchange (IPX) routing. Enter interface configuration mode. You have entered interface configuration mode when the prompt changes to Router(config-if)#. Enter the transmit clock mode for the selected ATM interface. The choices are internal, line, or loop. The default is line. For T1 interfaces only, specify the cable length (short or long) followed by the length in feet. You can view the acceptable cable lengths by including the ? option after the long or short commands. Specify the loopback type for this ATM interface by entering the loopback command followed by one of the following: line, local, payload, remote. You can view command descriptions by including the ? option after the loopback command. Configuring the IMA Interface To configure the IMA interface, follow this procedure: 3-24 Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers OL-1957-04