Cisco 7604 Software Configuration Guide - Page 716

Common QoS Scenarios Chapter 41 Configuring PFC QoS These are the three traffic classes in the sample network: • Voice • High-priority application traffic • Best-effort traffic The QoS configuration described in this section identifies and prioritizes each of these traffic classes. Note If your network requires more service levels, PFC QoS supports up to 64 traffic classes. These QoS scenarios describe the following three fundamental QoS configurations, which are often a general part of QoS deployment: • Classifying traffic from PCs and IP phones in the access layer • Accepting the traffic priority value on interswitch links between layers • Prioritizing traffic on interswitch links between layers These QoS scenarios assume that the network carries only IP traffic and use the IP DSCP values to assign traffic priority. These QoS scenarios do not directly use IP type of service (ToS) or Ethernet 802.1p class of service (CoS). IP packets can carry a priority value, which can be set at various points within the network topology. Best-practice design recommendations are to classify and mark traffic as close to the source of the traffic as possible. If traffic priorities are set correctly at the edge, then intermediate hops do not have to perform detailed traffic identification. Instead, they can administer QoS policies based on these previously set priority values. This approach simplifies policy administration. Note • You should develop a QoS deployment strategy for assigning packet priorities to your particular network traffic types and applications. For more information on QoS guidelines, refer to RFC 2597 and RFC 2598 as well as the various QoS design guides published by Cisco Systems, Inc. • Do not enable PFC QoS globally and leave all other PFC QoS configuration at default values. When you enable PFC QoS globally, it uses its default values. These are two problems that exist with the PFC QoS default configuration: - With PFC QoS globally enabled, the default trust state of the Ethernet ports in the system is untrusted. The untrusted port state sets the QoS priority of all traffic flowing through the router to the port CoS value (zero by default): all traffic will be zero-priority traffic. - With PFC QoS globally enabled, the port buffers are allocated into CoS-based queues and only part of the buffer is available for zero-priority traffic: zero-priority traffic has less buffer available than when PFC QoS is disabled. These problems with the PFC QoS default configuration can have a negative effect on network performance. Classifying Traffic from PCs and IP Phones in the Access Layer The access layer routers have a PC daisy-chained to an IP phone on a 100 Mbps link. This section describes how to classify voice traffic from the phone and data traffic from the PC so that they have different priorities. 41-114 Cisco 7600 Series Router Cisco IOS Software Configuration Guide, Release 12.2SX OL-4266-08