Cisco AIR-AP1142N-A-K9 Hardware Installation Guide - Page 81
Configuring Controller Information, Clearing Manually Entered Controller Information
View all Cisco AIR-AP1142N-A-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Chapter 4 Troubleshooting Lightweight Access Points Returning the Access Point to Autonomous Mode Configuring Controller Information To manually configure controller information on a new (out-of -the-box) access point using the access point CLI interface, you can use these EXEC mode CLI commands: AP# lwapp ap ip address AP# lwapp ip default-gateway IP-address AP# lwapp ap controller ip address IP-address AP# lwapp ap hostname name Where name is the access point name on the controller. Note The default (out-of-box) Enable password is Cisco. Clearing Manually Entered Controller Information When you move your access point to a different location in your network, you must clear the manually entered controller information to allow your access point to associate with a different controller. Note This command requires the controller configured Enable password to enter the CLI EXEC mode. To clear or remove the manually entered controller information, you can use these EXEC mode CLI commands: clear lwapp ap ip address clear lwapp ip default-gateway clear lwapp controller ip address clear lwapp ap hostname Manually Resetting the Access Point to Defaults You can manually reset your access point to default settings using this EXEC mode CLI command: Note This command requires the controller configured Enable password to enter the CLI EXEC mode. clear lwapp private-config Returning the Access Point to Autonomous Mode You can return a lightweight access point to autonomous mode by loading a Cisco IOS release that supports autonomous mode (such as Cisco IOS Release 12.3(7)JA or earlier). If the access point is associated to a controller, you can use the controller to load the Cisco IOS release. If the access point is not associated to a controller, you can load the Cisco IOS release using TFTP. OL-8369-05 Cisco Aironet 1130AG Series Access Point Hardware Installation Guide 4-9