Cisco CISCO876-K9 Configuration Guide - Page 137
ip address negotiated, encapsulation, dialer pool, dialer string, dialer-group, dialer-list, protocol
UPC - 882658036880
View all Cisco CISCO876-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 137 highlights
Chapter 13 Configuring Dial Backup and Remote Management Configuring Dial Backup and Remote Management Through the ISDN S/T Port Step 8 Command ip address negotiated Example: Router(config-if)# ip address negotiated Router(config-if)# Purpose Specifies that the IP address for the interface is obtained through PPP/IPCP (IP Control Protocol) address negotiation. The IP address is obtained from the peer. Step 9 encapsulation encapsulation-type Example: Router(config-if)# encapsulation ppp Router(config-if)# Sets the encapsulation type to PPP for the interface. Step 10 dialer pool number Example: Router(config-if)# dialer pool 1 Router(config-if)# Specifies the dialer pool to be used. In the example, the dialer pool 1 setting associates the dialer 0 interface with the BRI0 interface because the BRI0 dialer pool-member value is 1. Step 11 dialer string dial-string[:isdn-subaddress] Specifies the telephone number to be dialed. Example: Router(config-if)# dialer string 384040 Router(config-if)# Step 12 dialer-group group-number Example: Router(config-if)# dialer group 1 Router(config-if)# Assigns the dialer interface to a dialer group (1-10). Step 13 exit Example: Router(config-if)# exit Router(config)# Exits dialer 0 interface configuration mode, and enters global configuration mode. Step 14 dialer-list dialer-group protocol protocol-name {permit | deny | list access-list-number | access-group} Example: Router(config)# dialer-list 1 protocol ip permit Router(config)# Creates a dialer list for packets of interest to be forwarded through the specified interface dialer group. In the example, dialer-list 1 corresponds to dialer-group 1. For details about this command and additional parameters that can be set, see the Cisco IOS Dial Technologies Command Reference. OL-5332-01 Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide 13-19