Cisco CISCO878-SEC-K9 Configuration Guide - Page 101
bridge-group, interface, bridge, route, ip address, Step 3
UPC - 882658021787
View all Cisco CISCO878-SEC-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
Chapter 9 Configuring a Wireless LAN Connection Configure Bridging on VLANs Step 3 Command or Action bridge-group number Example: Router(config)# bridge-group 1 Router(config)# Step 4 bridge-group number parameter Example: Router(config)# bridge-group 1 spanning-disabled Router(config)# Step 5 interface name number Example: Router(config)# interface bvi 1 Router(config)# Step 6 bridge number route protocol Example: Router (config) # bridge 1 route ip Router(config)# Step 7 ip address address mask Example: Router(config)# ip address 10.0.1.1 255.255.255.0 Router(config)# Purpose Assigns a bridge group to the interface. Sets other bridge parameters for the bridging interface. Enters configuration mode for the virtual bridge interface. Specifies the protocol for the bridge group. Specifies the address for the virtual bridge interface. Repeat Step 2 through Step 7 above for each VLAN that requires a wireless interface. OL-5332-01 Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide 9-5