Cisco CISCO878-SEC-K9 Configuration Guide - Page 55
ip nat pool, netmask, prefix-length, ip nat inside source, interface, overload, Example
UPC - 882658021787
View all Cisco CISCO878-SEC-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
Chapter 4 Configuring PPP over ATM with NAT Configure Network Address Translation Receiver Gain: 22.5420 dB SNR Sampling: 36.8590 dB Dying Gasp: Present Configure Network Address Translation Network Address Translation (NAT) translates packets from addresses that match a standard access list, using global addresses allocated by the dialer interface. Packets that enter the router through the inside interface, packets sourced from the router, or both are checked against the access list for possible address translation. You can configure NAT for either static or dynamic address translations. Perform these steps to configure the outside ATM WAN interface with dynamic NAT, beginning in global configuration mode: Step 1 Command ip nat pool name start-ip end-ip {netmask netmask | prefix-length prefix-length} Purpose Creates pool of global IP addresses for NAT. Example: Router(config)# ip nat pool pool1 192.168.1.0 192.168.2.0 netmask 255.255.255.0 Router(config)# Step 2 Step 3 ip nat inside source {list access-list-number} {interface type number | pool name} [overload] Example 1: Router(config)# ip nat inside source list 1 interface dialer 0 overload or Example 2: Router(config)# ip nat inside source list acl1 pool pool1 interface type number Example: Router(config)# interface vlan 1 Router(config-if)# Enables dynamic translation of addresses on the inside interface. The first example shows the addresses permitted by the access list 1 to be translated to one of the addresses specified in the dialer interface 0. The second example shows the addresses permitted by access list acl1 to be translated to one of the addresses specified in the NAT pool pool1. For details about this command and additional parameters that can be set, as well as information about enabling static translation, see the Cisco IOS IP Command Reference, Volume 1 of 4: Addressing and Services. Enters configuration mode for the VLAN (on which the Fast Ethernet LAN interfaces [FE0-FE3] reside) to be the inside interface for NAT. OL-5332-01 Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide 4-9