Cisco CP-7921G-A-K9 Administration Guide - Page 217
Checklist for Deploying the Cisco Unified Wireless IP Phone 7921G, Configuring the Wireless Network - cp e k9
View all Cisco CP-7921G-A-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 217 highlights
D A P P E N D I X Checklist for Deploying the Cisco Unified Wireless IP Phone 7921G The following topics provide an overview of procedures for adding Cisco Unified Wireless IP Phones to your network: • Configuring the Wireless Network, page D-1 • Configuring QoS Policies, page D-3 • Configuring the Cisco Unified Wireless IP Phone 7921G in Cisco Unified Communications Manager, page D-4 • Installing the Cisco Unified Wireless IP Phone 7921G, page D-7 Configuring the Wireless Network Table D-1 explains and provides references for many of the configuration activities for the Cisco Aironet Access Point, controller, and Ethernet switch. Note When deploying the Cisco Unified Wireless IP Phone 7921G with World regulatory domain (CP-7921G-W-K9), you must enable the access points for world mode (802.11d). The world model phone gets the channels and power information from the access point. Table D-1 Wireless Network Configuration Tasks Activity Explanation Reference 1. Check that the Cisco IOS version is the recommended version • Under System Software, verify that Cisco Interacting with Cisco Unified Wireless IOS version 12.3(8)JA or later is running on APs, page 2-9 the AP. • For the controller, use Version 4.0 and Cisco IOS version 12.3(8)JX or later. 2. Configure a VLAN for voice Isolate voice traffic and enable QoS by configuring a separate voice VLAN on the access point and network switch. Voice QoS in a Wireless Network, page 2-10 Cisco IOS Software Configuration Guide for Cisco Aironet Access Points, Cisco IOS Release 12.3(8)JA OL-15985-01 Cisco Unified Wireless IP Phone 7921G Administration Guide for Cisco Unified Communications Manager Release 7.0 D-1