Cisco SF100D-05 Quick Start Guide - Page 3

1 Mounting the Cisco Unmanaged Desktop Switch The unmanaged desktop switch can be placed on a flat surface or mounted on a wall. Do not deploy the device in a location where any of the following conditions exist: High Ambient Temperature-The ambient temperature must not exceed 104 degrees Fahrenheit (40 degrees Centigrade). Reduced Air Flow-Both side panels must be unobstructed to prevent overheating. Mechanical Overloading-The device should be level, stable, and secure to avoid it sliding or shifting out of position. Circuit Overloading-Adding the device to the power outlet must not overload that circuit. Wall Mounting If you plan to mount this switch to a wall, you need 2 wallboard screws to mount the unmanaged desktop switch to the wall. We recommend using screws with a minimum of 0.17 inches (4.3 mm) width at the head and at least 0.55 inches (14.0 mm) long. Depending on your mounting surface, you might require longer screws or drywall anchors with a minimum of 0.30 inches (7.6 mm) width at the head and at least 0.59 inches (15.0 mm) long. WARNING Cisco is not responsible for damages incurred by insecure wallmounting. To mount the unmanaged desktop switch to the wall: STEP 1 Determine where you want to mount the unmanaged desktop switch. Verify that the surface is smooth, flat, dry, and sturdy. STEP 2 Drill two pilot holes into the wall surface. The distance between the screws should be: • Cisco SF 100D-05 = 1.70 in (43.0 mm) • Cisco SF 100D-08, Cisco SF 100D-16, and Cisco SG 100D-08 = 2.58 in (63.5 mm) Unmanaged Desktop Switch 2