Cisco SF100D-05 Hardware Installation Guide - Page 49

Chapter 3 Installing the Content Delivery Engines Installing the CDEs ISV System Specifically, the physical connections consist of the following: Interface Vault cache Vault ingest Vault management Streamer cache Streamer stream Streamer management CDSM management Switch Port Mbps Must be 1000 Can be 100/1000, but 1000 is recommended Can be 100/1000 Must be 1000 Must be 1000 Can be 100/1000 Can be 100/1000 In a system that uses ISVs that are collocated, the Ethernet cables are used to make the following physical connections: • ISV to switch • CDSM to switch Specifically, the physical connections consist of the following: Interface ISV ingest ISV management ISV stream CDSM management Switch Port Mbps Can be 100/1000, but 1000 is recommended Can be 100/1000 Must be 1000 Can be 100/1000 Installing or Removing Disk Drives The disk drives for the CDEs are shipped separately. You must install the disk drives before using the CDEs. A minimum of two disks are required for basic software installation (needed for the RAID-1 set). If the CDE is used to store content (configured as an SE), more than two disks are needed. For maintenance or other reasons, it may become necessary to remove a disk drive from the chassis. The disk drives on the CDE100 are monitored using Self-Monitoring, Analysis, and Reporting Technology (S.M.A.R.T.) and statistics are displayed through the Administrative Interface, as well as sent to the CDSM. For more information about S.M.A.R.T., see the Cisco Internet Streamer CDS 2.0-2.1 Software Configuration Guide. The CDE100 contains 4 disk drives (see Figure 3-6), the CDE200 contains 12 disk drives (see Figure 3-7), the CDE300 contains 16 disk drives (see Figure 3-8), and the CDE400 contains 24 disk drives (see Figure 3-9). Figure 3-6 CDE100 Disk Drive Locations sda sdb sdc sdd 211859 OL-13478-03 Cisco Content Delivery Engine 100/200/300/400 Hardware Installation Guide 3-9