Cisco SF100D-05 Hardware Installation Guide - Page 65
Installing the Software
View all Cisco SF100D-05 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Chapter 4 Installing the Internet Streamer CDS Software and Initially Configuring a CDE Installing the Software b. If the USB CD-ROM drive is still not detected (not shown), press the Reset button again. If you are still unable to detect the CD-ROM drive at the BIOS level, contact Cisco Technical Support at the following URL: www.cisco.com/techsupport The system boots from the image on the CD. This requires a terminal server to be hooked up to the serial port of the CDE200. All communication is done through the serial port (see the "Before You Begin" section on page 4-1 for terminal server settings. Once the CD starts booting, it displays a spinning "|" symbol for approximately five minutes. Allow the booting to proceed and monitor the sequence from a remote terminal provided by the terminal server. The CD boot menu is displayed at the conclusion of this boot sequence: Welcome to the installer. The installer enables installation of a new software image onto your system, or recovers a previous image in the event that the hardware was changed. MODEL: CDE200 FLASH: found, directory validated COOKIE: valid IMAGE: DEVELOPMENT[jbohach-lnx02:/data/jbohach/ws/ipvideo/refact-dev-1 FLASHDEV: /dev/hdX Installer Main Menu: 1. Configure Network 2. Manufacture flash 3. Install flash cookie 4. Install flash image from network 5. Install flash image from cdrom 6. Install flash image from disk 7. Wipe out disks and install.bin image 8. Exit (and reboot) 9. Force manufacturing flash Choice [0]: Step 14 Confirm that the FLASHDEV: line near the top of the menu displays something similar to "/dev/hdX", where "X" can be any letter. a. If no flash device is found, choose Option 8 to exit and reboot, and enter the BIOS Setup menu again. Confirm that the BIOS detected the flash device. b. If the BIOS detects the CD-ROM drive but the CD installation menu is not displayed, this is an abnormal condition. You can use a different USB CD-ROM drive and attempt the procedure again, or contact Cisco Technical Support at the following URL: www.cisco.com/techsupport Installing the Software Perform the following steps to install the software: Step 1 Manufacture the IDE compact flash drive by selecting Option 2. This makes the IDE compact flash drive bootable. Enter Y to confirm the process. OL-13478-03 Cisco Content Delivery Engine 100/200/300/400 Hardware Installation Guide 4-13