Cisco WIP310-G1 User Guide - Page 12

Chapter 2 Chapter 2: Installing the WIP310 Installing the Battery Open the phone's back battery cover. Place the battery so that the metal contacts on the battery touch the metal contacts in the battery compartment. The battery fits only one way. Do not force. Replace the cover after the battery is installed. Installing the WIP310 The phone briefly displays a charging icon and the LED is solid red. When the LED is solid green, the phone is fully charged. NOTE: The battery needs to charge for at least 8 hours prior to the phone's initial use. Do not power on the phone until it has charged for at least 8 hours. Powering On the Phone Power on the phone by pressing and holding the Power/ End Call button for approximately five seconds until the screen is lit. The phone is ready to use when the Home screen appears (in approximately 30 seconds). Battery Installed Charging the Battery Inserting the Power Adapter Insert the power adapter into the charger and then insert the adapter into a wall outlet. Charge the phone by placing the phone into the charger. NOTE: You can also charge the phone using the USB cable. Connect one end to your phone and the other end to a USB port on your personal computer. Home Screen Powering Off the Phone Power off the phone by pressing and holding the Power/ End Call button until the screen becomes dark. Installing the Phone To use your Wireless-G IP Phone, you need the following: •• Access to a Wireless-B or Wireless-G network with Internet access •• An account with an Internet Telephony Service Provider (ITSP) To use your phone, you need to complete the following tasks: 1. Connect to a wireless network. 2. Register your phone with your ITSP. If you received your phone directly from your ITSP, it should be preconfigured and should perform this step automatically after you power on the phone. Wireless-G IP Phone 8