Cisco WS-C3750G-24TS-E1U Software Configuration Guide - Page 39
Step 2, Step 3 - e specifications
View all Cisco WS-C3750G-24TS-E1U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Chapter 2 Using the Setup Command Facility Configuring Global Parameters Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph (c) of the Commercial Computer Software - Restricted Rights clause at FAR sec. 52.227-19 and subparagraph (c) (1) (ii) of the Rights in Technical Data and Computer Software clause at DFARS sec. 252.227-7013. Cisco Systems, Inc. 170 West Tasman Drive San Jose, California 95134-1706 Step 2 Cisco Internetwork Operating System Software IOS (tm) C2600 Software (C2600-JS-M), Version 11.3(2)XA, PLATFORM SPECIFIC RELEASE SOFTWARE (fc1) Copyright (c) 1986-1998 by cisco Systems, Inc. Compiled Tue 10-Mar-98 14:18 by rnapier Image text-base: 0x80008084, data-base: 0x809CD49C cisco 2611 (MPC860) processor (revision 0x100) with 24576K/8192K bytes of memory. Processor board ID 04614954 M860 processor, part number 0 mask 32 Bridging software. X.25 software, Version 3.0.0. 2 Ethernet/IEEE 802.3 interface(s) 3 Serial network interface(s) 32 terminal line(s) DRAM configuration parity is disabled. 32K bytes of non-volatile configuration memory. 8192K bytes of processor board System flash (Read/Write) --- System Configuration Dialog --- At any point you may enter a question mark '?' for help. Use ctrl-c to abort configuration dialog at any prompt. Default settings are in square brackets '[]'. When the following message appears, enter yes to begin the initial configuration dialog: Would you like to enter the initial configuration dialog? [yes/no]: Note If you answer no to this message, you are prompted to terminate AutoInstall. AutoInstall is a procedure that configures a new router based on the configuration of an existing router. If you terminate AutoInstall, you enter the Cisco IOS software CLI. Note The interface numbering that appears in the next step is dependent on the type of Cisco modular router platform. This example shows a Cisco 2600 series router. Step 3 When the following message appears, press Return to see the current interface summary: First, would you like to see the current interface summary? [yes]: Any interface listed with OK? value "NO" does not have a valid configuration Interface Ethernet0/0 Serial0/0 BRI0/0 IP-Address unassigned unassigned unassigned OK? Method Status NO unset up NO unset up NO unset up Protocol up down up OL-1957-04 Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers 2-3