Cisco WS-C3750V2-48TS-E Hardware Installation Guide - Page 104
Connecting to the 10/100 and 10/100/1000 Ports
View all Cisco WS-C3750V2-48TS-E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 104 highlights
Connecting to the 10/100 and 10/100/1000 Ports Chapter 3 Switch Installation Figure 3-39 Removing a Bale-Clasp Latch SFP Module by Using a Flat-Blade Screwdriver 86554 13 13X 14 15 16 17 18 19 20 21 22 23 24 23X 14X 24X Catalyst 3750 SERIES 1 2 1 1 Bale clasp Step 5 Step 6 Grasp the SFP module between your thumb and index finger, and carefully remove it from the module slot. Place the removed SFP module in an antistatic bag or other protective environment. Connecting to the 10/100 and 10/100/1000 Ports The switch 10/100 and 10/100/1000 ports configure themselves to operate at the speed of attached devices. If the attached ports do not support autonegotiation, you can explicitly set the speed and duplex parameters. Connecting devices that do not autonegotiate or that have their speed and duplex parameters manually set can reduce performance or result in no linkage. To maximize performance, choose one of these methods for configuring the Ethernet ports: • Let the ports autonegotiate both speed and duplex. • Set the port speed and duplex parameters on both ends of the connection. 3-44 Catalyst 3750 Switch Hardware Installation Guide 78-15136-02