Cisco WS-C3750V2-48TS-E Hardware Installation Guide - Page 106
Connecting to an SFP Module
View all Cisco WS-C3750V2-48TS-E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
Connecting to an SFP Module Chapter 3 Switch Installation Step 3 Step 4 might not be turned on, or there might be a cable problem or a problem with the adapter installed in the attached device. See Chapter 4, "Troubleshooting," for solutions to cabling problems. Reconfigure and reboot the connected device if necessary. Repeat Steps 1 through 3 to connect each device. Figure 3-40 Connecting to an Ethernet Port SYST RPS MASTR STAT DUPLX SPEED STACK MODE 12 1X 34 56 78 9 10 11 12 11X 2X 12X 86818 Connecting to an SFP Module This section describes how to connect to SFP modules. For instructions on how to connect to fiber-optic SFP modules, see the "Connecting to 1000BASE-T SFP Modules" section. For instructions on how to connect to 1000BASE-T SFP modules, see the "Connecting to 1000BASE-T SFP Modules" section. For instructions about how to install or remove an SFP module, see the "Installing and Removing SFP Modules" section on page 3-40. 3-46 Catalyst 3750 Switch Hardware Installation Guide 78-15136-02