Clifford Cyber 3 Owners Guide - Page 12
Smart AutoTesting™, Automatic malfunction bypass, TotalRecall™
View all Clifford Cyber 3 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Smart AutoTesting™ Each time you remotely arm your Cyber 3, it automatically performs an extensive test of all system triggers and sensors. If the hood or trunk is open when you remotely arm, the system will immediately alert you of the problem by sounding 4 chirps and 4 parking light flashes instead of the usual 2 and 2 (simply disarm, shut the hood or trunk and re-arm to reactivate monitoring of that trigger point). If a door is ajar or if a sensor is malfunctioning, you will receive the usual 2 chirps and 2 flashes, then, 5 seconds later, there will be 4 chirps and 4 flashes. (The door ajar warning will not work on vehicles that have factory-delayed courtesy lights). NOTE: Since this is a warning indication, you will hear the 4 chirps even if you have the chirp muting feature turned on. Specific malfunction identification: The system can also indicate the specific malfunctioning trigger or sensor. If you get the 4-chirp/4-flash signal upon arming, perform the following to identify the malfunctioning trigger or sensor: 1. Remotely disarm, then turn on the ignition. The LED status indicator inside your vehicle will be blinking, pause, then repeat. 2. Count the number of blinks in one cycle between pauses (for your convenience, the blink cycle repeats a total of 5 times) and refer to the chart below: Number of LED blinks between pauses Trigger/sensor indication 1 blink Piezo Sensor 2 blinks* Door trigger* 3 blinks Hood or trunk trigger * If your vehicle has a factory-installed feature that turns off or dims the interior courtesy lights several seconds after you exit the vehicle, the system cannot provide this indication. Automatic malfunction bypass The system automatically bypasses any faulty point and arms all other triggers and sensors to provide the utmost possible protection until you can have the system serviced by your local Authorized Clifford Dealer. TotalRecall™ The system's memory records the identity of the last activated or malfunctioning trigger or sensor, which allows your installer to instantly track down a malfunction. To identify the trigger or sensor held in memory, use the following procedure: 1. With the ignition OFF, flick the valet switch. 2. Press button 1 to "arm" the system, then again to "disarm." 3. The LED will blink 1-3 times. For your convenience, the blink cycle will pause and repeat a total of 5 times. Refer to the chart above. 11