Clifford Digital Dual Zone Proximity Sensor 4 60-585 Owners Guide - Page 2

Fled LEL) confirms inner zone activation Ana PPOItifDitty Green LED oonfirms outer zone activation erstep green LEDs indicate sensitivity level Increase and decrease sensitivity Select zone The innovative sensor control panel of the Digital Dual-Zone Proximity Sensor IV makes setting sensitivity for each of the two zones a breeze. The control panel window has five LEDs: four green LEDs to indicate the 32-step sensitivity level of each zone, and a red LED on the left to confirm inner zone activation. The last green LED on the right also doubles as the outer zone activation light that visually indicates whenever the outer zone senses motion. Each green LED has 8 different steps to indicate sensitivity setting: OFF, six steps of slow to rapid flashing, and constant ON. To increase or decrease sensitivity of either the exterior or interior zone, simply do the following: 1. Select the zone you wish to adjust by sliding the "select zone" knob. 2. Press the minus (-) button once to lower sensitivity one step of the plus (+) to increase sensitivity. The green LEDs will indicate the change as noted above. 3. Exit the vehicle and test your new setting. The red inner zone LED should flash when you lean your body into the passenger compartment, but should ignore any movement outside the vehicle windows. The green outer zone LED should flash only when there is movement within about one foot of the windows. NOTE: Ifyou can's see the control panel while testing, arm your alarm, wait at least 10 seconds, then put your hands and face up to the window to see inside the vehicle. You should get the warning. Lean into the vehicle through an open window You should get the full alarm activation. 4. If needed, use the (+) and (-) buttons to make further adjustments, then retest. If the other zone needs adjustment, repeat steps 1-4. Copyright Clifford Electronics, Inc., 1994 31-254A/DPS4OM/1294