Clifford IntelliGuard 700IQ Owners Guide - Page 12

What each button/channel does Your IntelliGuard 700-IQ remote controls come pre-programmed so that certain channels command certain functions. If you wish, you can actually assign any channel except 9 through 12 to any function (see pages 20-24). The following chart indicates what each remote control channel number does, and how to transmit each channel number. Factory settings of the 12 remote control channels Transmitting channel number: Causes the system to: Press the How Press LevelShift many button button? times? number 1 arm or disarm and lock or unlock the doors no - 1 2 pop the trunk* (if the system is disarmed) no - 2 3 silently arm or disarm no - 3 4 activate optional accessory function #1 no - 4 5 activate optional accessory function #2 yes once 1 6 activate optional accessory function #3 yes once 2 7 activate optional accessory function #4 yes once 3 8 activate optional accessory function #5 yes once 4 9 remotely enter or exit valet mode (see pages 14) yes twice 1 10 remotely override optional sensor #2 (see page 15) yes twice 2 11 remotely adjust sensitivity of the Piezo Sensor's primary zone (see page 15) yes twice 3 12 remotely adjust sensitivity of the Piezo Sensor's warning zone (see page 15) yes twice 4 TO ARM Press button 1 (channel 1) once. You will hear two chirps and the THE SYSTEM parking lights will flash twice. The dashboard LED will flash repeatedly and the car doors will automatically lock.* TO DISARM THE SYSTEM Press button 1 (channel 1) again. One chirp and one parking light flash confirms disarming. In addition, the doors will automatically unlock* and the interior lights will turn on and stay on for 30 seconds or until you start the engine, whichever occurs first. TO SILENTLY Press button 3 (channel 3). Your IntelliGuard 700-IQ system will ARM OR DISARM arm or disarm with all the indications noted above except for the THE SYSTEM chirp acknowledgments. * Some vehicles require optional relays and wiring. 10