Clifford IntelliGuard 700IQ Owners Guide - Page 20

3. The LED will blink 1-5 times to indicate the most recently activated point, pause, blink 1-5 times to indicate the next most recently activated point, and so on. 4. Write down the number of blinks between pauses and refer to the chart above. Smart prior intrusion attempt alert Number of LED blinks between pauses 1 blink 2 blinks 3 blinks 4 blinks 5 blinks Sensor/trigger indication Piezo Sensor Optional sensor Door trigger Trunk trigger Hood trigger If you hear three chirps when you remotely disarm, it means that a trigger or sensor was activated in your absence. When you enter the vehicle and turn on the ignition (or start the engine), the LED will blink 1-5 times, pause, then repeat the blink cycle 4 more times. Count the number of blinks in one cycle and refer to the chart below: High-output MultiSound Medallion™ Siren All the siren electronics are in the system control unit rather than the siren itself. This protects them from heat, dirt and exposure to the elements (other alarm companies' sirens are far more susceptible to failure). Your IntelliGuard 700-IQ also provides these additional features: Personalized Siren Sounds: Most alarm sirens have a single "warble" tone. A few offer "six-tone" sirens that either cannot be adjusted or require the physical destruction of certain circuit wires in order to change the sounds (the change is permanent and cannot be changed again). Your MultiSound Medallion Siren is different. As shipped from the factory, the siren sounds six different alarm sound patterns. However, you may turn any of the six alarm sounds on or off to create a different combination of sound patterns. In all, there are 64 different combinations you may select. If you set your own Personalized Siren Sounds and later hear a siren at a distance, you will know for sure whether it is your car or someone else's. See User-selectable features on pages 20-24. QuietChirps™: You can control the volume of the normal arm and disarm chirps. As shipped from the factory, your system issues full-volume chirp acknowledgments. If you prefer, you may reduce the chirp volume to a level that is clearly audible, yet less obtrusive. See the User-selectable features section on pages 20-24. Long-term chirp silencing: Whenever you wish, you may silence your IntelliGuard 700-IQ's arm and disarm chirps until you decide to restore them. The parking light flashes will continue to provide visual confirmation of remote controlled arming and disarming. See User-selectable features on pages 20-24. 18