Cobra 29 LX BT Operating Instructions - Page 9

Operation Operation Calibrate for SWR continued Note When switched to SWR mode the meter reading should ideally be as far to the left as possible. Anything over 3 is not acceptable. A slight antenna height adjustment (higher or lower) may be required. Repeat recalibration steps. R 5 Release the PTT button, press and release the S/RF-SWR CAL button to the SWR position. Then press the PTT button to read the SWR reading. 6 Repeat the same steps two through five on Channel 1 and 40. This will check SWR for all channels. To Receive To Receive R 1 Rotate the On/Off Volume knob clockwise. The RX icon will be displayed. 12 Selecting A Channel RX F SIG 1 3 5 7 9 +30dB DYNAMIKE MENU PU SH ENTER MEM RF GAIN DEL Selecting A Channel MIN MIN MAX Unit should be in CB mode. Rotate channel 1 selector clockwise or counter-clockwise to select desired channel. S-Meter Swings proportionately to strength of incoming signal when receiving. S-Meter SWR 1.5 2 3 S/RF RF CAL RX VOL SIG 1 SQ 3 5 7 9 +30dB MENU PU SH EN DYNAMIKE 1 The S/RF-SWR-CAL switch must be in the S/RF setting to read the meter. 13