Cobra 29 LX MAX 29LX_MAX_MANL.pdf - Page 7
Selecting A Channel, To Receive, Calibrate for SWR
View all Cobra 29 LX MAX manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Operation Operation Calibrate for SWR continued Selecting A Channel Note When switched to SWR mode the meter reading should ideally be as far to the left as possible. Anything over 3 is not acceptable. A slight antenna height adjustment (higher or lower) may be required. Repeat recalibration steps. NB/ANL S/RF SWR/CAL NB/ANL SWR 1.5 ANL SWR SIG 1 VOL SQ 23 CAL TX RX 3 5 7 9 +30dB RF GAIN MENU PUSH ENTER NB/ANL S/RF SWR/CAL MEM WX ! NB/ANL SWR 1.5 2 3 CASL CAN CH 9/19 ANL S/RF RF RX MEM SCAN DIM SIG 1 3 5 7 9 +30dB CB/MWENXU PUSH EENSTCER VOL SQ RF GAIN MEM WX ! DYNAMIKE DYNAMIKE DELTA TUNE T BACK SWR CAL OFF MIN MAX MIN SCAN CH 9/19 MEM SCAN DIM CB/ WX ESC DELTA TUNE T BACK SWR CAL OFF OFF MIN MAX 5 Release the PTT button and press and release the S/RF-SWR CAL button to the SWR position. Then press the PTT button to read the SWR reading. MIN OFF 1 Rotate the channel selector clockwise or counter- clockwise to select the desired channel. 6 Repeat the same steps two through five on Channel 1 and 40. This will check SWR for all channels. To Receive S-Meter The S-Meter swings proportionately to the strength of the incoming signal when receiving. NB/ANL S/RF NB/ANL SWR 1.5 2 3 ANL S/RF RF CAL RX SWR/CAL VOL SIG 1 SQ 3 5 7 9 +30dB NB /ANL MENU PUSH ENTER MEM SW/XR!F RF GAIN DYNAMIKE SWR/CAL OFF MIN MAX MIN SCAN CH 9/19 NB/ANL SWR 1.5 2 3 ANL MEM SCAN DIM S/RF CB/ WX ESC CAL RX DELTA TUNE TSBIGACK 1 VOL SQ OFF SCWAL3R 5 7 9 +30dB MENU PUSH ENTER RF GAIN 1 Rotate the On/Off Volume knob clockwise. While receiving, the RX icon will be displayed and the lower portion of the meter will show the incoming signal strength. 12 1 The S/RF-SWR-CAL button must be set in the S/RF setting to read the meter. OFF MIN MAX 13 MEM WX ! DYNAMIKE MIN DEL