Cobra CPI 480 CPI480_MANL - Page 5
Quick Evaluation, Before Installation, Installation, Requirements - inverter
View all Cobra CPI 480 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Introduction Quick Evaluation Before Installation Test Load A test load that can be plugged into the AC receptacle on the inverter for short term testing at a low power level. To check your inverter's performance before installation: On/Off Switch to Off 1. Turn the inverter off (see page 11 for details). If the power source is a DC power supply, switch it off as well. Connect Terminals 2. Connect cables to power input terminals (see page 6 for details). 3. Connect cable to power source (see page 8 for details). Connect Power Source 4. Check to make sure all connections are secure. 5. Turn the inverter on. If the power source is a DC power supply, switch it on first. 6. Plug in the test load. On/Off Switch to On Connect Test Load The inverter should supply power to the load. If the inverter is not working properly, refer to the troubleshooting guide on page 14 or power and protection indicators section on page 12. Installation Installation Requirements Installation Requirements • The inverter must be installed in an area that meets all of the following requirements: A. Dry Do not place in an area where water can drip or splash on the inverter. B. Cool Ambient air temperature should be between 30°F and 105°F (0°C and 40°C). The cooler the better. C. Ventilate Allow at least one inch (three cm) of clearance around the inverter for proper airflow. Make sure that ventilation openings on the ends of the unit are not obstructed. CAUTION To avoid fire, do not cover or obstruct ventilation openings. Do not install inverter in a zeroclearance compartment. Overheating may result. CAUTION The inverter must only be connected to batteries with a nominal output voltage of 12 volts. It will not work with a 6 volt battery, and will be damaged if it is connected to a 16 volt battery. WARNING This unit contains components which can produce arcs or sparks. To prevent fire or explosion, do not install in compartments containing a battery or flammable materials, or in a location which requires ignition protected equipment. USB Connection 4 Nothing Comes Close to a Cobra® 5