Cobra MR F55B-D MRF55D_MANL_ENG - Page 19
Transmit Power Output, Transmit A Message, Channels
View all Cobra MR F55B-D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Operating Your Radio Voice Transmission Voice Transmission • Transmit mode gives you the ability to communicate with safety services, other vessels, and shore stations. When you use this capability, be sure to follow the procedures and to observe the courtesies that govern its use so everyone benefits. (The tables on pages 14 through 23 will help you select the proper channels.) Before pressing the Talk button to transmit a message, you should select the appropriate channel and transmit power output. Channels You can transmit voice messages on most VHF Channels. Refer to the VHF marine channel assignments on pages 14 through 23 to select a channel according to the type of message you are going to send. Up/Down Buttons To Change The Channel You Can Choose From One (1) Of The Following: Channel 16/9 Buttons I Press the Up/Down buttons. This will take you to the next higher or lower VHF channel. (When on Channel 88A, the next higher channel is Channel 1 and vice versa.) For rapid advance, press and hold the Up or Down buttons. (The confirmation tone will sound only for each button press, not during rapid advance.) I Press the Channel 16/9 button. This will take you to Channel 16 with one (1) press and to Channel 9 with a second press. Additional presses will toggle between Channel 16 and Channel 9. Press and hold the Channel 16/9 button to return to Standby mode. 32 English Operating Your Radio Voice Transmission Transmit Power Output Your radio can Transmit selectively at 1 or 25 watts of power. Cobra suggests you maintain the low power setting for short-range communications and to avoid overpowering nearby stations with your signal. Use the high power setting for long-range communications or when you do not receive a response to a signal sent at 1 watt. High/Low Power Button To Toggle Between The High And Low Power Modes: Press the High/Low Power button. The LCD will show which mode is in effect. High/Low Power Some channels are restricted to use at a maximum of one (1) watt. Your radio will automatically set the power to Low Power mode when you select those channels. While using the U.S.A. channel map, if, in an emergency, you need to increase the output power on Channel 13 and Channel 67 for your signal to be heard, you can override the Low Power mode by pressing and holding the High/Low Power button. Low Power Setting Two (2) Inches [Five (5) cm] From Mouth Talk Button Transmit A Message To Transmit A Message: 1. Check to see that your unit is set to a proper channel for the type of message being sent. 2. Toggle to the low power setting by pressing the High/Low Power button. 3. With the microphone about two (2) inches [five (5) cm] from your mouth, press and hold the Talk button and speak into the microphone. TX (Transmit) displays on the LCD display. 4. Release the Talk button when you are finished speaking. To hear a response, the Talk button must be released. Transmit Icon NOTE If the Talk button is held down for five (5) minutes, the radio will automatically cease transmitting to prevent unwanted signal generation. As soon as the Talk button is released, it can be pressed again to resume transmission. Nothing Comes Close to a Cobra® 33