Cobra MR HH600 FLT GPS BT MR HH600 Manual - English - Page 9

VOHpFerMatainrigneYoRuardRioaPdirootocols Intro HH600 Radio Operation Secondary Icons Installation Notice Getting Started Customer Warranty GAsesisttatniceng Started • Refer to the foldout at the front of this manual to identify the various controls and indicators on your radio. Throughout this manual Customer Assistance you will be instructed to "Press" or to "Press and Hold" various buttons (except "Push to Talk") on the radio. "Press" means a momentary press of approximately one (1) second. "Press and Hold" means to hold the button down for approximately two (2) seconds. Whenever you press any button except the Talk button on your raCdaiuotio,na brief Wtoanrneing(if key tones are selected On) will sound to confirm the button press. With all button presses, the appropriate icon will appear on the LCD and the backlight will turn On. The backlight will stay On for 10 seconds after the button is released. in Icons Intro condary Icons Tones And Alarms When your Cobra Marine VHF radio is On, you can expect to hear the following tones and alarms. The volume of these sounds is controlled by the circuitry in the radio and is not affected by the volume set with the On-Off Power/Volume knob. Confirmation Tone Single high-pitched beep confirms all button presses except the Talk button. It can Operation be turned Customer Assistance OnWoarrraOntyff. See set-up routines on page 30. Error Tone Three low-pitched beep indicates an invalid button press. DSC Distress Alarm Installation Customer Assistance High-low-high-low-high. Pause, then repeat. The volume of all alarms will increase after 10 seconds. Press any button to turn it Off. NOTE This alarm sounds only for DSC distress calls on Channel 70. Notice It does Caution not soWuarnnindg for voice calls on Channel 16 - you still must listen for those. Distress Acknowledgement Alarm High-low-high-low-high. Pause, then repeat. The volume of all alarms will increase after 10 seconds. Press any button to turn it Off. DSC Routine Call Alarm High-pause-high-pause-high. Long pause, then repeat. Press any button to turn it Off. DSC Geographical Alarm Loud, continuous, medium-pitched, high-low tones (warble) - sounds when a geographical call is received. Press any button to turn it Off. 12 English Getting Started VOHpFerMatainrigneYoRuardRioaPdirootocols Intro Operation Customer DSC Position Request AlaArsmsistance Warranty Medium-loud, continuous, low-pitched series of closely spaced, four (4) beeps [three (3) short - one (1) long] groups - sounds when a position request call iDsSrCecIenidveivdi.dPuraelsInAsstalalalanrtiomyn buttoCAnsussitstotomanectreurn it Off. HSigechon-darypIcaonusse-high-pause-high. Long pause, then repeat. Press any button to turn it Off. Weather Alarm Medium-loud, continuous, Notice medium-pitched series Caution Warning of one-half (1⁄2) second beeps spaced one-half (1⁄2) second apart - sounds when weather alert is turned On and NOAA sends a 1050 Hz weather alert tone on the selected weather channel. Press any button to turn it Off. Common Radio Functions The following procedures define common operating functions of the radio when in either Marine Standby or Weather (WX) Standby modes. On/Off/Volume Control (Clockwise) Power/Volume Control Power On/Off Control The On/Off/Volume control is located at the upper right side of the radio. Turning the On/Off/Volume control past the detent position will turn the radio On or Off. Volume Control Volume is controlled by turning the On/Off/Volume control. On/Off/Volume Control (Counterclockwise) n To increase the volume, turn the On/Off/Volume control clockwise. n To decrease the volume, turn the On/Off/Volume control counterclockwise. Nothing Comes Close to a Cobra® 13