Compaq 5017m Reference Guide - Page 11

Installation ✎ After you turn on the monitor, install the Compaq LCD Display Assistant utility included on the CD-ROM. Use the on-screen instructions to adjust the picture quality of your monitor. To install this utility, follow the instructions on the "Configuring Your Compaq LCD Monitor" card located in the Program License Agreement packet. Important: Always activate a screen saver program, the programmable sleep timer, the Compaq Display LiteSaver utility, or turn off the monitor when it is not in use for a prolonged period of time. All LCD monitors that display the same static image on screen for a prolonged period of time may exhibit screen image retention. Note that image retention is not a permanent condition and will fade over a period of time. Image retention is a condition that may occur on all LCD screens. Monitor Base Removal (Optional) If you choose to mount the monitor onto a swing arm or other mounting fixture, you must remove the base from the monitor. Ä CAUTION: Before beginning to disassemble the monitor, be sure the monitor is turned off and the power and signal cables are both disconnected. To remove the base from the monitor, complete the following steps: 1. Lay the front bezel down on a soft area to prevent it from getting scratched, defaced, or broken. 2. Remove the two screws 1 from the back of the monitor as shown in the following illustration. Reference Guide 3-3