Compaq 8000 Technical Reference Guide: HP Compaq 8000 Elite Series Business De - Page 110
A.19 SCSI Interface Error Messages (65xx-xx, 66xx-xx, Table A-18, SCSI Interface Error Messages
UPC - 884420665106
View all Compaq 8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
Error Messages and Codes A.19 SCSI Interface Error Messages (65xx-xx, 66xx-xx, 67xx-xx) Table A-18 SCSI Interface Error Messages Message Probable Cause Message Probable Cause 6nyy-02 Drive not installed 6nyy-33 Illegal controller command 6nyy-03 Media not installed 6nyy-34 Invalid SCSI bus phase 6nyy-05 Seek failure 6nyy-35 Invalid SCSI bus phase 6nyy-06 Drive timed out 6nyy-36 Invalid SCSI bus phase 6nyy-07 Drive busy 6nyy-39 Error status from drive 6nyy-08 Drive already reserved 6nyy-40 Drive timed out 6nyy-09 Reserved 6nyy-41 SSI bus stayed busy 6nyy-10 Reserved 6nyy-42 ACK/REQ lines bad 6nyy-11 Media soft error 6nyy-43 ACK did not deassert 6nyy-12 Drive not ready 6nyy-44 Parity error 6nyy-13 Media error 6nyy-50 Data pins bad 6nyy-14 Drive hardware error 6nyy-51 Data line 7 bad 6nyy-15 Illegal drive command 6nyy-52 MSG, C/D, or I/O lines bad 6nyy-16 Media was changed 6nyy-53 BSY never went busy 6nyy-17 Tape write-protected 6nyy-54 BSY stayed busy 6nyy-18 No data detected 6nyy-60 Controller CONFIG-1 register fault 6nyy-21 Drive command aborted 6nyy-61 Controller CONFIG-2 register fault 6nyy-24 Media hard error 6nyy-65 Media not unloaded 6nyy-25 Reserved 6nyy-90 Fan failure 6nyy-30 Controller timed out 6nyy-91 Over temperature condition 6nyy-31 Unrecoverable error 6nyy-92 Side panel not installed 6nyy-32 Controller/drive not connected 6nyy-99 Autoloader reported tape not loaded properly n = 5, Hard drive = 6, CD-ROM drive = 7, Tape drive yy = 00, ID = 03, Power check = 05, Read = 06, SA/Media = 08, Controller = 23, Random read = 28, Media load/unload A-18 www.hp.com Technical Reference Guide