Compaq Armada 1100 Armada 1100 Family of Personal Computers Maintenance and Se - Page 111
Removing the PC Card PCMCIA Rails
View all Compaq Armada 1100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
14. From the front of the computer, tilt the system board up, then lift the system board out of the system chassis (Figure 5-49). At this time, remove the PCMCIA rails from the system board if you have not ordered or acquired a replacement set of rails for the new system board you are about to install. If you need to remove the rail set, refer to "Removing the PC Card (PCMCIA) Rails" in Section 5.14. 15. Remove the flex ground bracket from above the serial port connector between the system board and the system chassis (Figure 5-50).
14. From the front of the computer, tilt the system board up, then lift
the system board out of the system chassis (Figure 5-49).
At this time, remove the PCMCIA rails from the system board if you have not
ordered or acquired a replacement set of rails for the new system board you
are about to install. If you need to remove the rail set, refer to
"Removing the PC Card (PCMCIA) Rails" in Section 5.14.
15. Remove the flex ground bracket from above the serial port connector
between the system board and the system chassis (Figure 5-50).