Compaq Deskpro 6000 Compaq Reference Guide Deskpro 4000 and Deskpro 6000 Serie - Page 117
Removing a Drive from the Drive Cage, Removing the Power Supply
View all Compaq Deskpro 6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 117 highlights
Removing a Drive from the Drive Cage Removing the Power Supply To remove a drive from the drive cage, complete the following steps: 1. If you have locked the Smart Cover Lock, use Computer Setup to unlock the lock. For more information about Computer Setup, refer to Chapter 8, "Using Compaq Utilities." 2. Turn off the computer, disconnect the power cord from the electrical outlet, and remove the computer cover and front bezel. 3. Remove the screws securing the drive cage and slide the drive cage forward out of the chassis. 4. Remove the two screws securing the drive to the drive cage. If you are removing a 3.5-inch standard drive, you may need to remove the expansion board cage to gain access to the drive cage screws. 5. Disconnect the drive power and signal cables and, if it is a CD-ROM drive or PD-CD Drive, disconnect the audio connector. 6. Remove the drive from the drive cage and store in antistatic packaging. To remove the power supply, complete the following steps: ! WARNING: This procedure should be performed only by qualified personnel. Disconnect the power cord from the electrical outlet and the computer before removing the power supply. Failure to disconnect the power before opening the computer can result in personal injury or equipment damage. 1. If you have locked the Smart Cover Lock, use Computer Setup to unlock the lock. For more information about Computer Setup, refer to Chapter 8, "Using Compaq Utilities." 2. Remove the computer cover and front bezel. Reference Guide 6-35