Compaq dc5850 Technical Reference Guide: HP Compaq dc5850 Series Business Desk - Page 66
Network Interface Controller - drivers xp
View all Compaq dc5850 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
Input/Output Interfaces 5.9 Network Interface Controller These systems provide 10/100/1000 Mbps network support through a Broadcom BMC5754 network interface controller (NIC), a PHY component, and a RJ-45 jack with integral status LEDs (Figure 5-10). The support firmware is contained in the system (BIOS) ROM. The NIC can operate in half- or full-duplex modes, and provides auto-negotiation of both mode and speed. Half-duplex operation features an Intel-proprietary collision reduction mechanism while full-duplex operation follows the IEEE 802.3x flow control specification. Green LED RJ-45 Connector Broadcom BMC5754 NIC Tx/Rx Data LAN I/F Tx/Rx Data Yellow LED LED Green Yellow Function Activity/Link. Indicates network activity and link pulse reception. Speed: Off = 10 Mb/s, yellow = 100Mb/s, green = 1 Gb/s. Figure 5-10. Network Interface Controller Block Diagram The Network Interface Controller includes the following features: ■ VLAN tagging with Windows XP and Linux ■ Multiple VLAN support with Windows XP ■ Power management support for ACPI 1.1, PXE 2.0, WOL, ASF 1.0, and IPMI ■ Cisco Etherchannel support ■ Link and Activity LED indicator drivers The controller features high and low priority queues and provides priority-packet processing for networks that can support that feature. The controller's micro-machine processes transmit and receive frames independently and concurrently. Receive runt (under-sized) frames are not passed on as faulty data but discarded by the controller, which also directly handles such errors as collision detection or data under-run. The NIC uses 3.3 VDC auxiliary power, which allows the controller to support Wake-On-LAN (WOL) and Alert-On-LAN (AOL) functions while the main system is powered down. ✎ For the features in the following paragraphs to function as described, the system unit must be plugged into a live AC outlet. Controlling unit power through a switchable power strip will, with the strip turned off, disable any wake, alert, or power mangement functionality. 5-16 www.hp.com Technical Reference Guide