Compaq dc7900 Service Reference Guide: HP Compaq dc7900 Business PC - Page 246
Diagnostic Front Panel LEDs and Audible Codes continued, Table C-2 - hp beep codes
View all Compaq dc7900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 246 highlights
Table C-2 Diagnostic Front Panel LEDs and Audible Codes (continued) Activity Beeps Possible Cause Recommended Action Red Power LED flashes four 4 times, once every second, followed by a two second pause. Beeps stop after fifth iteration but LEDs continue until problem is solved. Power failure (power 1. Open the hood and ensure the 4 or 6-wire supply is overloaded). power supply cable is seated into the connector on the system board. OR 2. Check if a device is causing the problem by The incorrect external removing ALL attached devices (such as power supply adapter is hard, diskette, or optical drives, and being used on the USDT. expansion cards). Power on the system. If the system enters the POST, then power off and replace one device at a time and repeat this procedure until failure occurs. Replace the device that is causing the failure. Continue adding devices one at a time to ensure all devices are functioning properly. 3. Replace the power supply. 4. Replace the system board. OR The USDT power supply adapter must be at 135W and use the Smart ID technology before the system will power up. Replace the power supply adapter with the HP-supplied USDT power supply adapter. Red Power LED flashes five 5 times, once every second, followed by a two second pause. Beeps stop after fifth iteration but LEDs continue until problem is solved. Pre-video memory error. CAUTION: To avoid damage to the DIMMs or the system board, you must unplug the computer power cord before attempting to reseat, install, or remove a DIMM module. 1. Reseat DIMMs. 2. Replace DIMMs one at a time to isolate the faulty module. 3. Replace third-party memory with HP memory. 4. Replace the system board. Red Power LED flashes six 6 times, once every second, followed by a two second pause. Beeps stop after fifth iteration but LEDs continue until problem is solved. Pre-video graphics error. For systems with a graphics card: 1. Reseat the graphics card. 2. Replace the graphics card. 3. Replace the system board. For systems with integrated graphics, replace the system board. Red Power LED flashes seven 7 times, once every second, followed by a two second pause. Beeps stop after fifth iteration but LEDs continue until problem is solved. System board failure (ROM detected failure prior to video). Replace the system board. 234 Appendix C POST Error Messages