Compaq dx6100 HP Business Desktop dx6100 Series Personal Computers Service Ref - Page 159
Processor, Preparation for Disassembly, Computer Cover, Fan Shroud., Heatsink
View all Compaq dx6100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 159 highlights
Removal and Replacement Procedures- Slim Tower (ST) Chassis 7.16 Processor 1. Prepare the computer for disassembly (Section 7.1, "Preparation for Disassembly"). 2. Remove the computer cover (Section 7.5, "Computer Cover"). 3. Remove the fan shroud. Section 7.12, "Fan Shroud". 4. Disconnect the heatsink control cable from the system board and remove the heatsink (Section 7.15, "Heatsink"). 5. Rotate the locking lever to its full open position 1. 6. Raise and rotate the microprocessor retainer to its fully open position 2. 7. Carefully lift the processor from the socket 3. Ä CAUTION: Do NOT handle the pins in the processor socket. These pins are very fragile and handling them could cause irreparable damage. Once pins are damaged it may be necessary to replace the system board. Ä CAUTION: The heatsink must be installed withing 24 hours of installing the processor to prevent damage to the processor's solder connections. To install a new processor: 1. Place the processor in its socket and close the retainer. 2. Secure the locking lever. If reusing the existing heatsink, go to step 3. If using a new heatsink, go to step 6. 3. If reusing the existing heatsink, clean the bottom of the heatsink with the alcohol pad provided in the spares kit. Service Reference Guide, dx6100 361293-003 7-41