Compaq dx7500 Hardware Reference Guide - dx7500 Microtower Model - Page 20
Installing Additional Memory, DIMMs, DDR2-SDRAM DIMMs - memory upgrade
![]() |
View all Compaq dx7500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Installing Additional Memory The computer comes with double data rate 2 synchronous dynamic random access memory (DDR2SDRAM) dual inline memory modules (DIMMs). DIMMs The memory sockets on the system board can be populated with up to four industry-standard DIMMs. These memory sockets are populated with at least one preinstalled DIMM. To achieve the maximum memory support, you can populate the system board with up to 8-GB of memory configured in a highperforming dual channel mode. DDR2-SDRAM DIMMs For proper system operation, the DDR2-SDRAM DIMMs must be: ● industry-standard 240-pin ● unbuffered PC2-6400 800 MHz-compliant ● 1.8 volt DDR2-SDRAM DIMMs The DDR2-SDRAM DIMMs must also: ● support CAS latency 5 DDR2 800 Mhz (5-5-5 timing) and CAS latency 6 DDR2 800 Mhz (6-6-6 timing) ● contain the mandatory JEDEC SPD information In addition, the computer supports: ● 512Mbit, 1Gbit, and 2Gbit non-ECC memory technologies ● single-sided and double-sided DIMMs ● DIMMs constructed with x8 and x16 DDR devices; DIMMs constructed with x4 SDRAM are not supported NOTE: The system will not operate properly if you install unsupported DIMMs. 14 Chapter 2 Hardware Upgrades ENWW
![](/manual_guide/products/compaq-dx7500-hardware-reference-guide-dx7500-microtower-model-ca1ada3/20.png)