Craftsman 24222 Owners Manual - Page 7

ASSEMBLY OF HOPPER BAG STEP 10- ASSEMBLE UPPER TUBES , Fit the ends of the two upper hopper tubes into the ends of a rear hopper tube. Align the holes in the ends of the tubes and insert plastic plugs (R). See figure 7. NOTE: Either side of the rear hopper tube can face up. REAR HOPPER TUBE STEP 12 - ASSEMBLE TUBES TO BAG , Unfold the hopper bag, reverse the fold of the mesh wind screen and then lay the bag out flat with the wind screen on top= , insert the ends of the assembled upper hopper tubes down through the stitched sleeves in the sides of the hopper bag and then slide the tubes back underneath the wind screen. See figure 9. STmTCHED SLEEVE UPPER HOPPER TUBE _:__ UPPER FIGURE 7 FIGURE 9 STEP 11 - ASSEMBLE LOWER TUBES , Fit the ends of the two lower hopper tubes into the ends of a rear hopper tube. Align the holes in the ends of the tubes and insert plastic plugs (R). See figure 8= , insert a clevis pin (O) from the outside into each lower hopper tube and secure it with a hair cotter pin (M). See figure 8= NOTE: Either side of the rear hopper tube can face up. REAR HOPPER TUBE_,_ PLASTIC PLUG (B) _ CLEVIS PiN (O) Place the assembled lower hopper tubes into the bottom of the hopper bag and then slide the tubes to the back of the bag. See figure 10. Attach the ends of the lower hopper tubes to the inside of the upper hopper tubes using two clevis pins (N) inserted from the inside, and two hair cotter pins (M)= See figure 10= UPPER HOPPER HAURCOTTER PUN(M) FIGURE 8 TUBE LOWER HOPPER TUBE _ 3LEVmSPmN (N) FIGURE 10 7