Craftsman 27233 Operation Manual - Page 9

CLEARING A JAMMED NAIL (FIGURE 3) 1. Unplug the cord and remove all brads from the magazine. 2. Remove the two screws and washers (1) located on the tacking mouth cover. 3. Remove the cover (2). 7. Replace all parts in reverse order. 8. Tighten screws. 9. Make sure that the safety lock pin is correctly sticking out of the tacking mouth assembly. Fig. 3 CAUTION: Be careful, the safety lock pin and spring may shoot forward. 4. Remove safety lock pin (3) and spring (4). NOTE: Safety lock pin (3) has a kineytheed solpoet noinng thoenptihnewchoicvher is(2s)e. ated 4_. 3_ 5. Remove the slot cover (5). 6. Remove the jammed nail. j/ _'_ t_ 5 PROBLEM PROBABLE CAUSE Nailer will net fire 1. Not plugged in 2. Circuit breaker tripped 3. Damaged cord Nail jammed 1. Dirty, rusty, or deformed nails 2. Incorrect nails Power loss 1. Damaged coil spring REMEDY 1, Plug in 2. Reset circuit breaker or fuse 3. Have replaced by Sears Service Center 1. Replace with new nails 2, Use recommended nail style and size 1. Have repaired by Sears Service Center Page 9