Craftsman 28813 Operation Manual - Page 30
TROUBLESHOOTING, unless, Sears, service
UPC - 071288130000
View all Craftsman 28813 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
TROUBLESHOOTING CHART: See appropriate section in manual unless directed to Sears service center PROBLEM CAUSE CORRECTION 7 Water in fuel. 7 Empty fuel tank and carburetor, refill tank with fresh gasoline and replace fuel filter. 8 Loose or damaged wiring. 8 Check all wiring. 9 Carburetor out of adjustment. 9 See "To Adjust Carburetor" in Service and Adjustments section. 10 Engine valves out of adjustment. 10 Contact a Sears or other qualified service center. Hard to start Engine will not turn over Engine dicks but will not start Loss of power 1 Dirty air filter. 1 Clean/replace air filter. 2 Bad spark plug. 2 Replace spark plug. 3 Weak or dead battery. 3 Recharge or replace battery. 4 Dirty fuel filter. 4 Replace fuel filter. 5 Stale or dirty fuel. 5 Empty fuel tank and refill tank with fresh, clean gasoline. 6 Loose or damaged wiring. 6 Check all wiring. 7 Carburetor out of adjustment. 7 See "To Adjust Carburetor" in Service and Adjustments section. 8 Engine valves out of adjustment. 8 Contact a Sears or other qualified service center. 1 Clutch/brake pedal not depressed. 1 Depress clutch/brake pedal. 2 Attachment clutch is engaged. 2 Disengage attachment clutch. 3 Weak or dead battery. 3 Recharge or replace battery. 4 Blown fuse. 4 Replace fuse. 5 Corroded battery terminals. 5 Clean battery terminals. 6 Loose or damaged wiring. 6 Check all wiring. 7 Faulty ignition switch. 7 Check/replace ignition switch. 8 Faulty solenoid or starter. 8 Check/replace solenoid or starter. 9 Faulty operator presence switch(es). 9 Contact a Sears or other qualified service center. 1 Weak or dead battery. 1 Recharge or replace battery. 2 Corroded battery terminals. 2 Clean battery terminals. 3 Loose or damaged wiring. 3 Check all wiring. 4 Faulty solenoid or starter. 4 Check/replace solenoid or starter. 1 Cutting too much grass/too fast. 1 Raise cutting height/reduce speed. 2 Throttle in "CHOKE" position. 3 Build-up of grass, leaves and trash under mower. 2 Adjust throttle control. 3 Clean underside of mower housing. 4 Dirty air filter. 4 Clean/replace air filter. 5 Low oil level/dirty oil. 5 Check oil level/change oil. 3O