Craftsman 28907 Operation Manual - Page 31
directed
View all Craftsman 28907 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
TROUBLESHOOTING CHART: See appropriate section in manual unless directed to Sears service center PROBLEM CAUSE CORRECTION Headlight(s) not fosrokinegquipped) Battery will not charge 1 Light switch is "OFF". 2 Bulb(s) or lamp(s) burned out. 3 Faulty light switch. 4 Loose or damaged wiring. 5 Blown fuse. 1 Bad battery cell(s). 2 Poor cable connections. 1 Turn light switch "ON". 2 Replace bulb(s) or lamp(s). 3 Check/replace light switch. 4 Check wiring and connections. 5 Replace fuse. 1 Replace battery. 2 Check/clean all connections. Loss of drive Engine "backfires" when turning engine "OFF" 3 Faulty regulator (if so equipped). 3 Replace regulator. 4 Faulty alternator. 4 Replace alternator. 1 Debris on steering plate (if equipped), 1 See "CLEANING" in the maintenance section. 2 Motion drive belt worn, damaged, or broken. 2 Replace motion drive belt. 3 Axle key missing. 3 Installaxle keyat rear wheel. See "TO REMOVE WHEEL" in the Service and Adjustments section. 1 Engine throttle control not se 1 Move throttlecontrol between between half and full speed (fast' half and full speed (fast) position position before stopping engine before stopping engine. Engine dies when tractor is shifted into reverse 1 Reverse operation system (ROS) is not "ON" while mower or other attachment is engaged. 1 Turn ignition key to ROS "ON" position. See Operation section. o Get a personalized maintenance plan for your home. 31