Craftsman 28910 Operation Manual - Page 32
To Remove Wheel
View all Craftsman 28910 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
TROUBLESHOOTING CHART: See appropriate section in manual unless directed to Sears service center PROBLEM Battery will not charge Loss of drive Engine "backfires" when turning engine "OFF" Engine dies when tractor is shifted into reverse CAUSE CORRECTION 1 Bad battery cell(s). 2 Poor cable connections. 1 Replace battery. 2 Check/clean all connections. 3 Faulty regulator (if so equipped). 3 Replace regulator. 4 Faulty alternator. 1 Freewheel control in "DISENGAGED" position. 2 Debris on steering plate (if equipped). 3 Motion drive belt worn, damaged, or broken. 4 Replace alternator. 1 Place freewheel control in "ENGAGED" position. 2 See "CLEANING" in the maintenance section. 3 Replace motion drive belt. 4 Air trapped in transmission during 4 Purge transmission. shipment or servicing. 5 Axle key missing. 5 Install axle key at rear wheel. See "TO REMOVE WHEEL" in the Service and Adjustments section. Engine throttle control not sel 1 between half and full speed (fast) position before stopping engine, Move throttle control between half and full speed (fast) position before stopping engine. 1 Reverse operation system (ROS) 1 Turn ignition key to ROS "ON" is not "ON" while mower or other position. See Operation section. attachment is engaged. 32