Craftsman 28910 Operation Manual - Page 9

INSTALL SEAT 1. Remove bolt and flat washer securing seat to cardboard packing and set aside for assembly of seat to tractor. Remove the cardboard packing and discard. 2. Connect switch to seat. 3. Place seat on seat pan so all three (3) bottom pads are positioned over large slotted holes in pan. J Seat / switch / Pad"'_,_ Slot Seat / pan "_ Wiring harness 4. Push down on seat to engage pads in slots and pull seat towards rear of tractor. 5. Raise seat and tighten bolt securely. 6. Remove tape and discard. 7. Lower seat into operating position and sit on seat. Press clutch/brake pedal all the way down. (f operating position is not comfortable, adjust seat. NOTE: You may now roll your tractor off the skid. Follow the appropriate instruction below to remove the tractor from the skid. _WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects. TO ROLL TRACTOR OFF SKID Operation section for location function of controls) (See and 1. Raise attachment lift lever to its highest position. 2. Release parking brake by depressing clutch/brake pedal. 3. Place freewheel control in "transmission disengaged position" (See "TO TRANSPORT" in Operation section of this manual). 4. Roll tractor forward off skid. 5. Remove banding holding the deflector shield up against tractor. Continue with the instructions that follow. Slot 3e Pad_ Flat washer \ pan Bolt Tab Adjustment handle TO ADJUST SEAT Grasp adjustment handle and pull up, slide seat to desired position and release adjustment handle. 9