Craftsman 37624 Owners Manual - Page 7

see TO CON

Get Craftsman 37624 - Front Propelled Rear Bag Lawn Mower PDF manuals and user guides View all Craftsman 37624 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 7 highlights

TO ASSEMBLE GRASS CATCHER 1. Put grass catcher frame into grass bag with rigid part of bag on the bottom. Make sure the frame handle is outside of the bag top. 2. Slip vinyl bindings over frame. NOTE: If vinyl bindings are too stiff, hold them in warm water for a few minutes. If bag gets wet, let it dry before using. Frame Vinyl bindings Frame opening TO PREPARE BATTERY NOTE: Your battery must be charged before you can start your lawn mower. 1. Disconnect engine battery connector (male) from battery connector (female) 2. Connect battery charger connector (male) to battery connector (female). 3. Plug battery charger into 110 volt A.C. outlet. 4. Leave battery charger connected for 24 hours before starting your engine for the first time. 5. After charging, connect engine connector (male) to battery connector (female). Connect your battery charger to charge battery as required. IMPORTANT: The engine will not recharge your battery. At the end of the mowing season the battery should be charged for 48 hours to ,_otect the battery during winter storage. CAUTION: Always disconnect the harness connector to prevent accidental starting when transporting or storing your lawn mower after the season. Engine battery connector (male) Battery charger Charger connector (male) Battery connector (female) TO INSTALL ATTACHMENTS Your lawn mower was shipped ready to be used as a mulcher. To convert mower to bagging or discharging, see "TO CONVERT MOWER" in the Operation section of this manual. 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
TO ASSEMBLE
GRASS
CATCHER
1.
Put grass catcher
frame
into grass bag
with
rigid part of bag on the bottom.
Make
sure the frame
handle
is outside
of the bag top.
2.
Slip vinyl bindings
over frame.
NOTE:
If vinyl bindings
are too stiff, hold
them
in warm
water
for a few minutes.
If
bag gets wet, let it dry before
using.
Frame
Vinyl
bindings
Frame
opening
TO PREPARE
BATTERY
NOTE:
Your battery
must be charged
before you can start your lawn mower.
1.
Disconnect
engine
battery
connector
(male)
from battery
connector
(female)
2.
Connect
battery
charger
connector
(male)
to battery
connector
(female).
3.
Plug battery
charger
into 110 volt A.C.
outlet.
4.
Leave
battery
charger
connected
for
24 hours before
starting
your engine
for the first time.
5.
After
charging,
connect
engine
con-
nector (male)
to battery
connector
(female).
Connect
your
battery
charger
to charge
battery
as required.
IMPORTANT:
The engine
will not re-
charge
your battery.
At the end of the mowing
season
the
battery
should
be charged
for 48 hours to
,_otect
the battery
during winter
storage.
CAUTION:
Always
disconnect
the
harness
connector
to prevent
accidental
starting
when transporting
or storing
your
lawn mower after the season.
Engine
battery
Battery
connector
(male)
charger
Charger
connector
(male)
Battery connector
(female)
TO INSTALL
ATTACHMENTS
Your lawn mower was
shipped
ready to be
used as a mulcher.
To convert
mower to
bagging
or discharging,
see "TO CON-
VERT
MOWER"
in the Operation
section
of this manual.
7